Argo S Service Manual page 66

Engine System
9. Slowly and gently lower the engine through the hood area. Some manuevering is
required as the engine does not necessarily drop in straight on. Avoid damage to any
vehicle components as well as the upper body. Photo 10 & 11
Align the mounting holes of the engine block with the powerpack frame studs. Once
aligned properly, the engine should just drop into place. Do not force or hammer in
any way. Damage may occur to the threads of the mounting studs.
Once the engine is seated into place, ensure that the rubber rad seal is properly
sealing at the face of the radiator. Photo 12
10. Locate the flat washer and nylon locknut used to secure the engine to the power
pack frame studs. Photo 13 Refer to your illustrated parts manual. Install all
four fasteners and Torque to specifications. Refer to step 12 of Removing The
Engine, for preferred wrenches used to retighten the nylon locknuts.
Ontario Drive & Gear Limited
PH. (519)- 662-2840 FAX (519)- 662-2421
10
IMPORTANT
IMPORTANT
12
EN-27A
Argo Service Manual
11
13
www.odg.com