Hydraulic Brake Caliper Reassembly - Argo S Service Manual

Brake System
8. Remove the bleed screws and check the
steel ball from the caliper casting. Photo
BR-12
9. Clean all components in a varsol bath,
then a mild soap solution. Use com-
pressed air to blow out the caliper cast-
ings. This will free up any dirt or other
contaminants you could not reach with
the cloth.
10. Wipe all components with a lint free cloth or use compressed air to dry.
11. Thoroughly inspect all the components. Replace any worn, cracked, or broken or
missing parts.
12. Inspect both piston chambers for any pitting, scratching, scarring or rust. Replace
pistons with new,or the entire caliper assembly if necessary.

Hydraulic Brake Caliper Reassembly

1. Begin with all the components on a clean surface.
2. Lubricate all component parts with fresh DOT 5 Silicon Brake Fluid
Do not allow brake fluid to contact your eyes, clothes, or painted surfaces. Brake
fluid is extremely corrosive and can cause severe personal injury. Wear protective
eye goggles, gloves and clothing. If brake fluid contacts your eyes, consult a
physician immediately.
Ontario Drive & Gear Limited
PH.(519)- 662-2840 FAX (519)- 662-2421
BR-10
BR-12
Argo Service Manual
BR-11
BR-12
www.odg.com