Personal Setup; Set Display Brightness; Ir Control Mode; Set Autoplay - AVM EVOLUTION CD 3.2 Operating Instructions Manual

4. Personal setup

Several settings can be done in the personal setup
To access the personal setup switch the unit to standby (power button (1)). Then press and hold the PROG
key (4). While holding that key switch the unit on (power button (1)).
The display now will show "**personal setup***". Release the PROG button (4) and the unit is in personal
setup mode.
When the personal setup is active you can select the desired function using the buttons < and > (2, 3). The
setting is done using the buttons I<< and >>I (13, 14). STOP (10) exits the personal setup and stores the
settings.

4.1 Set display brightness

Sets display brightness between 25% and 100%.
NOTE: The setting 100% can lead to "burn in" effects on the display if the unit is operated in this setting for a
very long time. So please switch the unit to stand by, if not in use.

4.2 IR control mode

Player only
In this mode the output level is fixed to maximum. The buttons STOP, PLAY, SKIP on the remote control are
used to control the CD drive. PLAY switches between play and pause if pressed several times. STOP ejects
the disc if pressed twice. SKIP if pressed for more than one second activates fast forward / rewind (only
while disc is playing). If pressed shortly the player will skip to the next / previous title.
All functions (the CD3.2 / 5.2 can be used as digital preamplifiers)
If this mode is activated the buttons STOP, PLAY, SKIP on the remote control are used to control the CD
drive as described above. Additionally the output volume can be set using the VOLUME buttons on the RC3,
input is selected using INPUT keys. CD is selected using the PLAY key.
If you own a RC8 instead of RC3 you can select the filters (buttons FILTER) and use the MUTE/UNMUTE
function. The RC8 provides also direct access to any input and has number keys to select a certain title
directly.

4.3 Set autoplay

When AUTOPLAY is ON, the CD player will start playing automatically every time a new CD is inserted. If
AUTOPLAY is OFF, the player will read the TOC of the inserted disc and then go to STOP mode.

4.4 skip unused inputs

Deactivate unused inputs ("SKIP"). The unit will then skip these inputs when the input select buttons < or >
(2, 3) are pressed or if you select the inputs via the remote control.

4.5 define input names

You can individually set the names (max. 8 characters) of the different sources shown in the display (8).
Proceed as follows:
Press < or > (2, 3) to select the input. Press REPEAT (6) to select the position and I<< or >>I to define the
character (holding the key pressed changes the character every half second).
11