Pigtail Installation For Binding Procedure - Russound Collage Installation Manual

Pigtail installation for binding procedure

A pigtail must be connected to the CAK1 keypad to temporarily power
the keypad during the naming, binding and network verification process.
This step is done BEFORE cutting any holes.
1. Use a section of an extension cord with a three-prong plug, leaving
at least three feet of cable to the stripped wire end.
2. Feed the stripped wire end through the bottom of the power
pocket. Secure with the strain relief.
3. Attach the cable's hot, neutral and ground leads to the flying leads
of the power supply and secure with wire nuts.
4. Insert the power supply into the power pocket. Feed the RJ45
communication cable and the terminated power plug through the
openings in the trade separator plate and snap the plate onto the
top of the power pocket.
5. Drop the power pocket into the back box, leaving the pigtail free at
the bottom of the power pocket.
6. Attach the terminated power plug and the RJ45 communication
cable to the back of the CAK1 keypad.
7. Secure the keypad to the back box by hand,
8. The pigtail can be left in place for location verification testing of
an electrical outlet. If testing from a light switch, attach an adapter
with clips on flying leads (see diagram to right) to test off the feed
supplying the light switch.
do not use a drill.
Russound Collage System Installation Manual
4
6
Trade Separator
Keypad
7
3
Adapter with clips on leads
(light switch test)
Keypad assembly with pigtail
INSTALLATION - pIGTAIL
5
5
4
3
1
2
Three-prong plug
(binding, outlet test)
9