Connector Panel - Panasonic PT-L785U Operating Instructions Manual

(continued from previous page)
: VOLUME +/- buttons (page 30)
These buttons are used to adjust the volume of the sound that is output
from the projector's built-in speakers and AUDIO OUT connector. Refer to
page 46 for details on how to adjust the volume using the buttons on the
projector control panel.
; ID SET/ALL button (page 23)
These buttons are used to set the projector ID number into the remote
control unit when using multiple projectors with a single remote control
unit.
< Operating mode (Computer, Projector) select switch (page 33)
Move this switch to the left side to use the remote control unit to operate a
computer, and move it to the right side to operate the projector.

Connector panel

# $
+
# Wired LAN connector
This connector is used to connect a personal computer to the projector in
order to externally control the projector. (10 Base-T/100 Base-TX)
Refer to the "Network Function Edition" operating instructions for details.
$ SERIAL connector (pages 20, 21 and 72)
This connector is used to connect a personal computer to the projector in
order to externally control the projector. (RS-232C compatible)
% RGB1 IN connector (pages 20 and 21)
This connector is used to input RGB signals and YP
16-E
NGLISH
% & ' ( )
, - .
P signals.
B R
*