Using The Cable Cover - Panasonic PT-L785U Operating Instructions Manual

Using the cable cover

Putting the power cord and remote control unit away
Installing the cable cover
#
Hook1
$
%
' ˛
Removing the cable cover
NOTE:
Do not lift up the projector by holding the cable cover, otherwise the cable
cover might come off.
62-E
NGLISH
Remote control unit
(Infrared emitter)
Hook2
Velcro
' ˛
( ˛
& ˛
$ ˛
$ ˛
%
#
#Put the remote control unit
into the cable cover with the
buttons facing downward to
prevent them from being
pressed.
$Put the power cord and other
cables into the cable cover.
%Put the Velcro through the
hole, and tape it to prevent
the cables from dropping out.
&Insert the hook 1 of the cable
cover into the mounting holes
in the projector.
'Push in the hook 2 until it
locks into place.
(Tighten the screw by turning it
clockwise.
#Loosen the screw by turning it
anticlockwise.
$Release the two hooks at the
top of the cable cover.
%Pull the cable cover to the
rear to remove it from the
projector.