Kärcher K 3.170 T 50 Operating Instructions Manual page 12

Safety instructions
 Only trigger the high-pressure jet at the
high-pressure gun if the T-Racer is lo-
cated on the surface to be cleaned.
 There must be no persons in the imme-
diate vicinity of the cleaning head.
 Beware of the recoil force! Ensure a
stable position and firmly hold the high-
pressure gun with the extension tube or
the handle.
 Switch off the high-pressure cleaner
when you finish cleaning. If you are us-
ing the T-Racer then disconnect the
same from the high-pressure gun.
 Maximum water temperature 60°C
(please observe the instructions of your
high-pressure cleaner).
Symbols on the machine
Danger!
Do not hold under the edge of the
T-Racer when it is on!
Description of the Appliance
When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
 See page 11, illustration
1 Casing
2 Bayonet connection with safety cover
3 Extension tube
4 High pressure nozzle
5 Rotor arm
Proper use
The T-Racer is ideally suited for the cleaning
of floor and wall surfaces made of different
materials, such as wood, plastic, concrete,
tiles, and natural stone. Use the T-Racer ex-
clusively in your private household.
12 English
Application
Note: Always use Kärcher water filter (or-
der no. 4.730-059.0) during suction opera-
tions of the high-pressure cleaner.
Cleaning floor surfaces
Fasten the T-Racer to the high-pressure
gun using the extension pipe.
 Illustration
1 Press the extension tube into the bayo-
net connection of the high-pressure
gun, then turn by 90° until it locks into
place.
2 Tighten the safety cover.
Repeat this process even for the other con-
nections.
Tips for cleaning
 Outdoor surfaces should be swept be-
fore the T-Racer is used to avoid dam-
aging the high-pressure nozzles.
 The T-Racer is not suited for scouring
or scrubbing!
Caution
 Illustration
Do not run over free-standing corners!
Cleaning wall surfaces
Fasten the T-Racer directly to the high-
pressure gun.
1 Press the bayonet connection of the T-
Racer into the connection of the high-
pressure gun, then turn by 90° until it
locks into place.
2 Tighten the safety cover.
Caution
 Illustration
Always hold the high-pressure gun with
both the hands while cleaning the walls.