Yamaha FZS600 2000 Supplementary Service Manual page 25

K Pass the wire harness inside of
the rear fender rib.
L Pass the wireharness under the
starter relay.
M Pass the starter motor lead un-
der the joint of the harness, then
pull upward.
N Set the fuel sender coupler in the
cross pipe of the frame.
O Use a plastic clamp to fasten to-
gether the wire harness and
cross pipe of the frame.
CABLE ROUTING
P Pass the fuel pump lead be-
tween the ignition coil and fuel fil-
ter, then push under.
Q Use a plastic clamp to fasten to-
gether the wire harness and
stay.
R Pass the carburetor inlet hose un-
der the high tension cord #2, #4.
S Use a clamp to fasten the clutch
cable and starter cable.
T Use a plastic clamp to fasten
high tension code #2, and #4.
–17–
SPEC
U Set the clamp, which is fixed to
the wire harness, in T-stud of the
frame.
V Put the wire harness into the box
through the groove at the back,
then connect it in the box.