York ERJC 36 Installation Instructions Manual page 8

by johnson controls
ERJC(36)R
2) During the transportation of the outdoor unit, two lifting ropes long enough must be used in four
directions and the separation angle must be less than 40°prevent the center of unit deviating.
4) The unit should be installed on a concrete base frame with a height of 10cm.
5) The installation space of the unit should be as required in Fig.5.
Installation Space Requirements of the Outdoor Unit: ERJC(36)R
3 Connection between Indoor and Outdoor Units
a. Wiring of the Power Cord
CAUTION
A breaker must be installed, capable of cutting off the power supply for the whole system.
1) Open the side plate.
2) Let the power cord go through the rubber ring.
3) Connect the power card to the terminals "L", "N" and also the earthing bolt, and then connect the
wiring terminals "N(1),2,3" of the indoor unit to those of the outdoor unit correspondingly.
4) Fix the power cord with wire clips.
8
1022
950
572 192
Fig.3
500
2000
Installation Instructions
ERJC(42)R
he support leg and base frame of the unit.
ERJC(42)R
2000
Fig.5
5
1087
1015
631 191
Fig. 4
1000
500