Replacing A Hard Drive - Pinnacle Systems Deko1000 Technical Reference And Service Manual

Chapter 5: System Maintenance
12. Place the computer's cover back on the computer.
Use a Phillips-head (+) screwdriver to reattach the screws securing the top cover to the
computer.
13. Return the damaged SVGA Card to Pinnacle Systems.
Place the damaged SVGA card into the antistatic bag that the replacement card was pulled
from, and send the damaged card to Pinnacle Systems per the instructions given by
Pinnacle Support.

Replacing A Hard Drive

Important: Remove a Hard Drive only if directed to do so by a Pinnacle Systems Customer Support
representative.
The Hard Drives are accessed from the front panel of a Deko1000 or Deko550 Workstation if it
becomes necessary to install a replacement. Refer to Figure 5-9.
Refer to Figure 5-10 for Hard Drive identification.
1. Shut down the computer and turn off the monitor.
Shut down the computer by going to the Start menu and selecting Shut Down (Start menu
>> Shut Down). Turn off the monitor after you are sure the computer has powered down.
Important: Do not attempt to open the computer while the computer is turned on. If you think the
computer is in sleep mode press the power button in front of the computer to wake it, and then shut
down the computer.
52
Figure 5-9: Workstation Front Panel (with panel cover removed)
Figure 5-10: Deko1000 and Deko550 Workstation Hard Drive
Deko1000 & Deko550 Technical Reference And Service Guide