Deko1000 And Deko550 Workstation Initial Setup - Pinnacle Systems Deko1000 Technical Reference And Service Manual

Deko1000 and Deko550 Workstation Initial Setup

Before installing the Deko1000 or Deko550 in your rack, the system should be put together,
powered up, and tested via a diagnostic test that comes pre-installed on the system. The steps for
initially setting up the workstation, powering it up, and testing it are as follows:
1. Visually inspect the hardware components listed in the "Unpacking" section on the pre-
vious page to make sure that none of them were damaged during shipment
If you received a hardware component that was damaged, contact Pinnacle Systems
Customer Support. Contact information can be found in Appendix A of this document.
2. Insert the System hard drive and Media hard drive into their respective drive bays on
the front panel of the Deko1000 or Deko550 workstation. Refer to Figure 3-1.
When placing a hard drive into its respective bay, align the drive so that it will properly slide
into the drive bay. Then push the drive so that it completely slides into the bay. This will
connect the drive to its connectors at the back of the bay. Use a screwdriver to completely
tighten the two thumbscrews. To insure that the connection stays intact, tighten the
thumbscrews as much as possible with the screwdriver.
Power
On/Off
Figure 3-1: Front Panel of Deko1000 or Deko550 Workstation (front panel cover removed)
3. Attach the mouse and keyboard to the back panel of the workstation.
The mouse and keyboard connections on the workstation are shown in Figure 3-2.
REDUNDANT POWER SUPPLIES
Figure 3-2: Back Panel of the Deko1000 or Deko550 Workstation
Deko1000 & Deko550 Technical Reference And Service Guide
SYSTEM SYSTEM
MEDIA MEDIA
LED LED
RS422A RS422A
MANUAL
SVGA BYPASS
MOUSE PARALLEL NETWORK
USB
USB
SERIAL UNUSED
KEYBRD
DVD CD-ROM
Floppy Drive
USB
Not Used
USB
VIDEO
IN
REFERENCE
VIDEO
OUT
KEY
IN
ALARM
SILENCE
KEY
OUT
Chapter 3: Installation And Setup
19