Exclude/Delete A Honeywell Thermostat; Exclude All Z-Wave Devices; Abort A Z-Wave Action - Honeywell Tuxedo Touch Series User Manual

SCAN SECURITY

Exclude/Delete a Honeywell Thermostat

To exclude a Honeywell Thermostat from the Z-Wave network, do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen, and then press the
Z-Wave Setup icon to display the "Z-
Wave Device Management" screen.
b) Highlight the thermostat and press the
Z-Wave Exclude/Delete icon.
2. At the thermostat:
a) Follow the instructions in the
thermostat Installation Guide under
"Installer setup" to "Remove a Z-Wave
Network Connection".
b) Once the exclusion process is complete,
press Done; the thermostat is excluded.

Exclude All Z-Wave Devices

ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the Z-
Wave Setup icon to display the "Z-
Wave Device Management" screen.
b) Press the Z-Wave Reset icon to delete
all devices from the controller.
c) Press the Continue or Cancel button.

Abort a Z-Wave Action

ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the Z-Wave
Setup icon to display the "Z-Wave Device
Management" screen.
b) Press the Z-Wave Abort Operation icon to
abort that process.
Automation (cont'd)
ACTION
IMPORTANT: Honeywell is not responsible for property damages due to
improper setting of the thermostat modes.
Z-Wave Exclude/Delete -clears the node from the keypad and resets device
to the default setting.
Note: To remove a defective device, refer to the " Z-Wave Troubleshooting "
section.
ACTION
The message is displayed:
WARNING!! This Z-WAVE controller is about to be factory defaulted and
will loose all devices in the enrolled list. All Z-WAVE devices must be
re-enrolled.
ACTION
NOTES
NOTES
NOTES
If inadvertently a wrong selection was made, (add, delete, or remove failed
device) user can press the Z-Wave Abort icon to abort the process.
38