Table of Contents
Advertisement
"FAST HEATING" FUNCTION
Turn the control knob anti-clockwise to the
setting and then release the knob (after the
"beep"); the relative
symbol lights up on the cooking zone display. Within 5 seconds
turn the knob to the desired power level (between 1 and 9); once a setting has been se-
lected,
and the chosen power level will flash in alternation on the control panel display.
This function allows the cooking zone to operate at the maximum power (100%) for a time
proportional to the selected power level; after this time the cooking zone will operate at the
selected level.
This function is available on all the cooking zones.
While this function is operating it is possible, at any time, to increase the selected power
level but it is not possible to decrease the power; by turning the knob anti-clockwise to a
lower level the function will be disabled.
The function will be disabled also by turning the knob to the "
" (Off) position or by selec-
ting the "Booster" function.
Note: If removing the pan from the cooking zone before the programme has been comple-
ted, the "Fast heating" function will be completed with the remaining time if the pan is put
back on the cooking zone within 10 minutes.
"BOOSTER" FUNCTION
Turn the control knob clockwise to set the maximum power level (9), then turn clockwise
again to the
setting and release the knob (after the "beep"); the control knob returns to
the maximum setting (9) automatically and the relative
symbol lights up on the cooking
zone display.
The "Booster" program is now operative.
This function allows the cooking zone to operate at the Booster maximum power (above
the nominal power) for maximum 5 minutes; it could be used, for example, to rapidly heat
up large amount of water.
This function is available only on the Ø 200 mm induction cooking zones.
To disable this function turn the knob anti-clockwise to a lower power level or to the "
"
(Off).
The "Booster" is also disabled by turning the knob again to the
setting; in this case the
cooking zone operates at the power level 9.
Note: if a cooking zone is still hot, it is not possible to use the "Booster" function and
will flash if you try to activate. The cooking zone is automatically set to the maximum power
level (9).
The "Booster" function is always limited to a maximum of 5 minutes. You can activate the
"Booster" function again after 5 minutes.
IMPORTANT NOTES: The "BOOSTER" function is not suitable for use with non water
based cooking.
Do not use this function for heating oil (e.g. deep fat frying)
14
Advertisement
Table of Contents
