Sharp XV-DW100U Service Manual page 9

Remote Control Positioning
• The remote control can be used to control the projector within the ranges shown below.
• The signal from the remote control can be reflected off the screen for easy operation. However, the effective distance of the
signal may differ due to the screen material.
Controlling the Projector
Remote control
23 (7 m)
30˚
45˚
30˚
Using the remote control in a dark room
Press BACKLIGHT to turn on the backlights of the operation buttons for about five seconds.
Remote control
BACKLIGHT button
Wired Remote Control
When the remote control cannot be used due to the range or positioning of the projector (rear projection, etc.),
connect a 3.5 mm stereo minijack cable (sold separately) from the wired remote control input on the bottom of the
remote control to the WIRED REMOTE control input terminal on the rear of the projector.
• The signal transmitter does not operate when the cable is connected to the remote control.
45˚
30˚
Remote control
Remote control
3.5 mm stereo minijack cable
(sold separately)
9
XV-DW100U