Replacing Crankshaft Front Seal - FENDT MAN D 0836 LE Workshop Manual

Fav 900 chassis number 23/3001 and up
Fav 900
PM-Picturemodule
PMTAB_Picture
PM-Picturemodule
PMTAB_Picture
PM-Picturemodule
PMTAB_Picture
PM-Picturemodule
PMTAB_Picture
Date Version Page
15.2.2001 a 1/1
Engine / Short block

Replacing crankshaft front seal

Removing vibration damper
Remove fan frame.
Remove power belt.
Unscrew vibration damper, remove vibration
damper.
Check vibration damper and washer for damage;
replace if necessary.
Remove oil splash ring.
Replacing crankshaft front seal
Lever out rotary shaftt with special tool.
Apply multi-purpose grease to sealing lips.
Fit new shaft sealing ring.
Note:
Do not damage sealing lips.
Use press-in plate to drive shaft sealing ring into
timing case until flush with recess .
Refitting the vibration damper
With surfaces free of grease and oil, position
vibration damper including oil splash ring, insert
screws and tighten to specified torque.
Refit power belt.
Place screws and tighten.
Replacing crankshaft front seal
Repair
G
Capitel Index Docu-No.
2210 G 000002