Power - Belts - FENDT MAN D 0836 LE Workshop Manual

Fav 900 chassis number 23/3001and up
Fav 900
PM-Picturemodule
PMTAB_Picture
PM-Picturemodule
PMTAB_Picture
PM-Picturemodule
PMTAB_Picture
PM-Picturemodule
PMTAB_Picture
Date Version Page
26.02.2001 a 1/3
Engine / Short block

Power - belts

Generator right
Checking condition
Power belt is maintenance free
Check belts for cracks, oiling-up, and signs of
overheating and wear.
Replace damaged belt.
Checking tension
Tensioning device (arrow) keeps permanently a
constant tension on the power belt.
Tensioner must be adjusted as follows:
1. New tensioner: distance (A) = 92 ±1 mm
(3.62" ±.04").
2. If distance (A) = 100 mm (3.94"), turn excenter
to right to reach a distance of (A) = 92 ± 1 mm
(3.62" ±.04"), at least that the excenter (1)
allows a reduction of A down to min 92 mm
(3.62").
3. If the distance reaches (A) = 100 mm (3.94")
and the excenter (1) is at the end position, the
power belt must be replaced. Adjust a new
power belt according to Point 1.
The replacement of the powerbelt becomes
necessary if the tensionning lever comes to rest
on console (Arrow).
Note:
Distance of 100 mm (3.94") may cause a total
failure of the belt drive because of insufficient
tension.
Power - belts
Repair
G
Capitel Index Docu-No.
2210 G 000016