Removing The Pwb Units - Sharp PG-C30XU Service Manual

3. Removing the PWB units

3-1. Disconnect the connectors from the output unit.
3-2. Remove the four PC I/F unit lock screws, and take out the PC I/F unit.
3-3. Remove the spacer (stud bolt) and the three screws off the output unit. Lift the output unit, together with the
signal unit, off the position.
3-4. Remove the S-out/REG unit angle lock screw and take out the S-out/REG unit.
PC I/F Unit
Signal Unit
PC Terminal Unit
3-3
3-1
(FP) (FS)
3-3
Video Unit
3-2
3-3
(FN)
(TP)
(L)
Spacer (stud bolt)
Output Unit
(Q)
(EB)
(SO)
(F)
(EB)
3-1
(SO)
15
PG-C30XU
3-4
S-out/REG Unit Angle
(EA)
(SP)
S-out/REG Unit