Lnb Supply Voltage; Modulator Connection; Tv And Video Recorder Connection; Audio Connection - Kathrein UFD 545 User Manual

Connection and Startup

LNB supply voltage

Modulator connection

Note

TV and video recorder connection

Audio connection

Inserting batteries in the remote control

If the feed system (LNB) is powered by an external supply voltage and the LNB
supply voltage is not used for switching over polarity (e.g. Kathrein feed system
UAS 330), the LNB supply of the receiver must be set to "OFF" (see section
"Installation menu, LNB configuration").
If your TV set is not equipped with a SCART socket, you can connect the receiver
by means of a coaxial cable. (See "Technical reference" at the end of this User's
Guide.)
For this purpose, connect the modulator output of the receiver to the antenna input
of the TV set.
The TV set must be preset to UHF channel 38. The modulator of your receiver
"transmits" on this channel (factory setting).
Stereo reproduction is not possible in this configuration! And a decoder for pay-TV
cannot be connected!
To use the receiver together with a video recorder, loop through the receiver signal
via the video recorder (antenna input and output). The output channel of the video
recorder must be selected such that the receiver signal is not adversely affected
and vice versa. Refer to the corresponding information provided in the User's
Guide of your video recorder. Also refer to the connection examples at the end of
this User's Guide!
Use a SCART cable to connect the satellite receiver (TV SCART) and TV set.
If your TV set is equipped for stereo output, you can receive the sound in stereo via
the SCART connection.
Also use a SCART cable to connect the satellite receiver (VCR/AUX SCART)
and the video recorder.
If you wish to reproduce the sound via a HiFi system, connect a corresponding
Cinch cable from the audio Cinch sockets on the receiver to the input sockets on
your HiFi system.
If your HiFi system features a digital input or you have a digital Dolby system, you
can connect it to the digital output.
Remove the cover on the battery compartment on the underside of the remote
control.
Insert the two supplied batteries in the remote control. Ensure correct polarity
of the batteries, the + and – markings are indicated inside the battery
compartment.
Slide the cover back into the casing and lock in position.
Used batteries are special waste! Therefore do not throw batteries into the
household waste but rather deposit them at a collection depot for old batteries!
15