Osd Language; Lnb Supply Voltage; Lnb Supply Voltage In Standby; Programme Selection - Kathrein UFD 400 Operating Manual

Initial settings
When making the setting, it should be ensured that there is at least one blank
channel above and below the output channel in order to avoid interference.

OSD language-

Here you can select the language for the on-screen displays. The choice available
comprises: German and English.
Default: German

LNB supply voltage

Here you can turn off the power supply for the feed system if this is implemented
by an external power supply and signal selection is likewise not carried out by
means of the LNB supply voltage (e.g. Kathrein single-cable feed system UAS
330).
Note If there are switchover matrices in the receiving system, the LNB supply voltage
needs to be turned in all cases..
Default: ON

LNB supply voltage in standby

When the receiver is in standby the LNB supply voltage is normally switched off.
If terrestrial signals and satellite signals are combined in the receiving system, and
the power supply for the relevant components comes from the receiver, the power
supply must also be guaranteed when the receiver is in standby.
In this case switch the power supply in standby to "On".
Default: "Off".

Programme selection

You have the option of entering the programme number in one-, two-, or three-digit
form or in "free" form
Default: "free".
If a recording is pre-programmed in the timer for a programme slot ≥100, the timer
Note
must be cleared first in order that a change in the programme slot entry can be car-
ried out.

On Screen Displays (OSD)

Here you can select whether the programme slot and programme name are to be
displayed continuously, or whether they are to be removed again approximately
three seconds after programme changeover..
This setting can be made differently in TV mode and radio mode.
To call the initial setup menu for radio, the receiver must be switched into radio
mode before being switched off. Then call the initial setup menu in the usual way.
24
All manuals and user guides at all-guides.com
Setting
One-digit input
Two-digit input
Three-digit input
Free input
Default: TV mode
Radio mode
Settable programme slots
Programme slots 1 to 9
Programme slots 1 to 99
Programme slots 1 to 250
Programme slots 1 to 250
"Off".
"On".