Front And Rear Panel Illustration - Nevir NVR-7017 TTCU User Manual

Front and Rear panel illustration

1. Front View
1) REMOTE CONTROL SENSOR: Receives the signal from the remote control.
2) SETUP: Used to adjust the brightness/contrast/color/hue parameter of TFT screen when
there is no menu on the screen.
3) SOURCE: To select input source.
4) CH+: Navigates the menu screens or selects the channels in non-menu state.
5) OK: Confirms a selection within a menu.
6) VOL+: Navigates the menu screens or adjusts the volume in non-menu state
7) VOL-: Navigates the menu screens or adjusts the volume in non-menu state.
8) CH-: Navigates the menu screens or selects the channels in non-menu state
9) MENU: Opens the main menu window.
10) ASPECT: Changes display mode 19:9 or 4:3
11) EXIT: Exits menu.
12) TFT screen: Displays the TFT widescreen display.
13) Antenna input: Connects to an external RF signal.
14) Speaker Left
15) USB
16) Memory Card slot
17) Speaker Right
2. Right View
1) AV IN JACK: This jack used to connect a external CVBS video and analog audio input.
2) AV OUT JACK: This jack outputs CVBS video and analog audio signal.
3 ) EARPHONE JACK: This jack outputs analog audio L/R signal to earphone.
4 ) POWER SWITCH: This switch used to switch on/off the system.
5 ) DC IN JACK: This is used for AC-DC adaptor input, the voltage range is 12V.
6 ) CHARGE INDICATOR: The system is in charging state when red LED is lighting, it will turn
1
into green when full charged.
.
2 3 4 5 6
4
.
.