JVC KS-T807 Service Manual page 7

3.1.7 Removing the cassette mechanism assembly
(See Fig. 8)
• Prior to performing the following procedure, remove the front
panel assembly, bottom cover, side panel, rear bracket and
main board.
• Remove the front chassis assembly as required.
(1) Remove the four screws J attaching the cassette mecha-
nism assembly on the top chassis.
(2) Take out the cassette mechanism assembly.
3.1.8 Removing the mecha control board
(See Fig.9)
• Prior to performing the following procedure, remove the front
panel assembly, bottom cover, side panel, rear bracket, main
board and cassette mechanism assembly.
(1) Disconnect the wire from the connector
mecha control board.
(2) Disconnect the card wire from the connector
mecha control board.
(3) Remove the screw K attaching the mecha control board.
(4) Bend the hook f in direction of the arrow 1 and move the
mecha control board in the direction of the arrow 2.
(5) Remove the mecha control board from the mecha bracket
(L) of the top chassis.
J
CN402 on the
CN403 on the
K
Cassette mechanism assembly
J
Top chassis
Fig.8
Mecha control board
CN402
CN401
CN403
Fig.9
J
J
Hook f
1
2
Mecha bracket (L)
(No.MA069)1-7