CHARNWOOD DX45iB & DX50iB Operating Installation Instructions Contents Operating Instructions General Points..........2 Fuels ............2 Door Operation ..........2 Multifuel Grate ..........2 Lighting ............3 Controlling The Fire ........3 Running The Fire With The Doors Open..3 System Controls ...........
MULTIFUEL GRATE Wood This appliance has been designed to conform with BS.3378. It has obtained Your Charnwood is fitted with a Only dry well seasoned wood should the approval of HETAS Ltd. (formerly multifuel grate which enables solid be burnt on this appliance as burning DSFAAS Ltd.) for burning the fuels...
To make ash removal easier there is a of the radiators and domestic hot special Charnwood ash carrier water. The automatic controls (other available. This may be purchased than thermostatic radiator valves) will...
The fire should be riddled with all position as required (the tool should kept clean. When burning smokeless doors shut. Place the tool on the knob be horizontal for solid fuel or vertical fuels they should be cleaned monthly. and rotate between the horizontal and for wood or peat).
left ajar. It is also advisable to sweep manufacturers instructions with regard the chimney and clean out the fire. to sweeping should be consulted. The Throat Plate is shown Spraying the inside of the doors and in the Smokeless fuel position TROUBLE SHOOTING firebox with a light oil, such as WD40, will also help to keep all...
Page 7
ventilate the room. After a chimney fire the chimney Chimney Fires. B) Let the fire out and safely should be carefully examined for any If the chimney is thoroughly and dispose of fuel from the appliance. damage. Expert advice should be regularly swept, chimney fires should C) Check for flue or chimney sought if necessary.
Health and Safety at Work Act 1974 manufacturers instructions and are met. The rated output for the DX45iB is Building Regulations. 10.1 kW (34500 btu/h) to water and Some types of fire cement are caustic 3.1 kW (10600 btu/h) to the room.
HEARTH 22mm Open Vents Feed and Expansion Tank Cold Water Tank The appliance must be installed on a fireproof hearth and must be situated Overflow Overflow at least 300 mm (12 inches) from any combustible material. The positioning of the appliance and the size of the Domestic Hot Water Draw Off hearth are governed by building regulations for Class 1 appliances.
return is used an injector tee must be size. Any large voids must be filled SYSTEM CONTROLS incorporated into the system as shown and flaunched to the flue pipe to in Fig. 10. This will ensure that a The circulating pump may be ensure that all soot deposits can be good domestic hot water supply is controlled by means of time switches,...
Fig. 11. dry out, the fire should be lit and checked to ensure that smoke and In most installations it will be possible The Throat Plate is shown fumes are taken from the appliance up in the Smokeless fuel position to sweep the chimney through the the chimney and emitted safely.