VKI Technologies Zuma Brewer Operation And Service Manual page 28

Zuma Brewer - Operation & Service Guide
9. While pressing down on the H-frame, insert the T-bar from the top of the brewer down into the
threaded section of the T-bar housing, and turn the T-bar approximately 20 turns clockwise. Once
done, install the T-bar into its recession on top of the H-frame.
NOTE: You have now successfully re-assembled the Zuma brewer, however, the brewer will not
function properly in its current state. You must now re-adjust the brewer chamber's tension. The
procedure for adjusting the brewer tension is outlined on page 8.
Page 28