Cleaning The Brewer (With Vki Powdered Brewer Cleaner) - VKI Technologies Zuma Brewer Operation And Service Manual

Zuma Brewer - Operation & Service Guide

Cleaning the Brewer (with VKI Powdered Brewer Cleaner)

To properly clean and de-stain the brewer without damaging the components, rinse the brewer using only a
VKI approved brewer cleaner (VKI p/n - M019610). The use of any other types of cleaning agents may cause
damage to plastic and rubber components on the brewer.
CAUTION: Do not soak plastic parts in brewer cleaner for prolonged periods of time as doing so will
make the plastic brittle and easy to damage. The maximum soak time is 30 minutes.
The following procedure outlines the "Brewer Rinse" cycle function that is available on all VKI equipment.
On non-VKI equipment, follow the manufacturer's recommended brewer rinsing instructions.
1. Place a leak-proof container underneath the brewer pour spout area.
2. Add VKI approved brewer cleaner to the brew chamber.
3. Press the "Rinse Cycle" button on the control panel inside the front door.
4. Press the "Coffee Rinse" button on the front selection panel to begin the cycle.
a) The piston will move to the top of the cylinder, water will pour in, and the brewer will pause for
about 5 minutes. During this time, the cleaner breaks down all of the oils and stains that have
accumulated in the brewer.
b) After the 5 minutes have elapsed, the brewer will cycle, dumping the cleaner into the waste
container in the process. The brewer will then automatically cycle water seven consecutive
times to rinse the cleaner from the brewer. After the rinse cycle is completed, the brewer will
stop and the coffee maker will automatically exit the rinse mode.
c) After the rinse cycle is complete, brew a few cups of coffee to re-lubricate the brewer.
Page 12