VKI Technologies Zuma Brewer Operation And Service Manual page 25

2. Move the spring and arm assembly up against the front inner wall of the mainframe (
two arm pins through the rear of the mainframe and through the holes in each arm (
the spring should now be sandwiched in between the arms and the wall of the mainframe. At the front
of the mainframe, insert a c-clip into each of the arm pins to secure the pins (and arms) in place (

At this point in the procedure, the brewer arm replacement is complete.
3. The next part of the procedure is to replace the triple cam and T-bar housing. Even if you were only
replacing one of the two, both of these components need to be removed.
Partially insert the bottom of the triple cam into the opening in the T-bar housing. While keeping the
triple cam angled towards the top of the brewer, slide the triple cam and housing into the brewer
mainframe. You need to get the top of the triple cam resting inside the opening for the crank arm on

the mainframe ( ), while the bottom is inside the opening in the T-bar housing (
Zuma Brewer - Operation & Service Guide





) and insert the

). At this point,

).

).
Page 25