Re-Assembling The Brewer - VKI Technologies Zuma Brewer Operation And Service Manual

Zuma Brewer - Operation & Service Guide
9. Pull the two arms and the large spring connected to the arms out through the bottom of the
mainframe.
NOTE: At this point in the procedure, the two arms can be completely removed.

Re-assembling the Brewer

1. Install the spring onto both of the brewer arms - note that the each end of the spring must be hooked
to each arm, as illustrated. With the spring in place, slide the spring and arm assembly into the
mainframe through the bottom of the brewer (the spring must be facing towards the front of the
brewer).
Page 24