Dimensions (WxHxD)
Weight
Output Format
* Antenna Features
1. Antenna Type
2. Inductance
3. Antenna Gain
4. Direction
5. Polarization
6. Connection with Transmitter
6. Installation
6-1. Drill two 6-32 or M3 holes 3.3"(8.38cm) apart in vertical and one 1/2" hole at the center of these two
holes. (If you have installed electric gang box then skip this step.)
6-2. Using two 6-32 or M3 screws, install wall mount to the wall.
6-3. Insert 5 O-rings to the wall mount as indicated, then route the cable of the main unit through the
center hole and push the main unit to wall mount to lock the main unit and make sure that the main
unit is locked with wall mount.
487mm(3.40")x100mm(3.94")x31mm(1.22")
190 g (0.412 lbs)
26bit Wiegand, RS-232, ABA Track II Magstripe Output Format
with 8bit Burst or 3x4 Matrix Format for PIN
SOLDER:5mm
30.0mm
59.5mm
65.0mm
Loop Coil Antenna
Primary Coil: 13uH,
Secondary Coil: 627uH
34.54DB
Omni-directional antenna
Horizontal Polarization
Soldering directly on PCB
H:2.3mm
5
Proximity Reader with KEYPAD