HIKVISION DS-9600 Series User Manual page 88

2) Click
Protect file by setting HDD property to Read-only
Steps:
1. Enter HDD setting interface.
Menu> HDD
2. Click to edit the HDD you want to protect.
Note: To edit HDD property, you need to set the storage mode of the HDD to Group. See
Chapter Managing HDD Group.
3. Set the HDD property to Read-only.
4. Click OK to save settings and back to the upper level menu.
Notes:
1. You can't save any files in a Read-only HDD. If you want to save files in the HDD, change
the property to R/W.
2. If there is only one HDD and is set to Read-only, the NVR can't record any files. Only live
view mode is available.
3. If you set the HDD to Read-only when the NVR is saving files in it, then the file will be
User Manual of DS-9600/8600/7700/7600 Series NVR
to change it to to unlock the file and the file is not protected.
Figure 5. 32 Unlocking Attention
Figure 5. 33 HDD General
Figure 5. 34 HDD General- Editing
87