Reassembly - Hitachi CJ 120V Technical Data And Service Manual

(8) Disassembly of the Change Knob [52] ([55]) (Fig. 12)
Being very careful not to lose Spring (C) [53] ([56]) and the Steel Ball D3.97 [54] ([57]) inside the Change
Knob [52] ([55]), remove the D5 Retaining Ring (E-type) for D5 Shaft [47] ([50]) from the end of the Change
Knob [52] ([55]), and remove the Change Knob [52] ([55]) from the Gear Cover [45] ([48]).
Steel Ball D3.97 [54] ([57])
Spring (C) [53] ([56])
Change Knob [52] ([55])

10-2. Reassembly

Reassembly can be accomplished by following the disassembly procedures in reverse. However, special attention
should be paid to the following points.
(1) Assemble Spring (C) [53] ([56]) and the Steel Ball [54] ([57]) in the Change Knob [52] ([55]) as shown in Fig. 13.
Retaining Ring (E-Type)
for D5 Shaft [47] ([50])
(2) Confrim that the Connecting Piece [32] ([35]) surely fits into the Connector [31] ([34]) as shown Fig. 14.
Connector [31] ([34])
Gear Cover [45] ([48])
Connecting Piece [32] ([35])
Gear Cover [45] ([48])
Retaining Ring (E-type)
for D5 Shaft [47] ([50])
Fig. 12
Steel Ball D3.97 [54] (57])
Spring (C) [53] ([56])
Change Knob [52] ([55])
Fig. 13
Fig. 14