Hitachi CJ 110M Handling Instructions Manual
Hide thumbs
Also See for CJ 110M:
- Handling instructions manual (32 pages) ,
- Handling instructions manual (32 pages)
Table of Contents
Advertisement
Quick Links
Jig Saw
Model CJ 110M
Handling instructions
Note:
Before using this Electric Power Tool, carefully read through these
HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is
recommended that these INSTRUCTIONS be kept readily available
as an important reference when using this power tool.
CJ 110MV
•
CJ110MV
Advertisement
Table of Contents
Related Manuals for Hitachi CJ 110M
Summary of Contents for Hitachi CJ 110M
-
Page 1: Handling Instructions
Jig Saw Model CJ 110M CJ 110MV • Handling instructions CJ110MV Note: Before using this Electric Power Tool, carefully read through these HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important reference when using this power tool. -
Page 2: General Safety Rules
A wrench or a key left attached to a rotating part of GENERAL SAFETY RULES the power tool may result in personal injury. e) Do not overreach. Keep proper footing and balance WARNING! at all times. Read all instructions This enables better control of the power tool in Failure to follow all instructions listed below may result in unexpected situations. -
Page 3: Specifications
PRECAUTIONS ON USING JIG SAW This Jig saw employs a high-power motor. If the machine is used continuously at low speed, an extra load is applied to the motor which can result in motor seizure. Always operate the power tool so that the blade is not caught by the material during operation. - Page 4 NOTE: 6. Adjusting the orbital operation Confirm the protrusions of blade inserted to the blade (1) This Jig Saw employs orbital operation which moves holder surely. (Fig. 2) the blade back and forth, as well as up and down. Set the change knob shown in Fig.
- Page 5 9. Chip cover CUTTING Chip cover prevents chips from flying off and improves the efficiency of dust collector. CAUTION: Insert the chip cover between the base and lever, and In order to prevent blade dislodging, damage or push with a slight pressure until it catches in place. excessive wear on the Plunger, please make sure to (Fig.
- Page 6 (4) Set the orbital position to “0”. (2) In other materials NOTE: When cutting a window hole in materials other than To ensure accurate cutting when using the Guide lumber, initially bore a hole with a drill or similar tool (Fig.11), always set the orbital position to “0”.
- Page 7 NOTE: CONNECTING WITH CLEANER Dial scale reading is for reference only. The higher the speed is, the quicker the material is cut. But the By connecting with cleaner (sold separately) through dust service life of the blade will be reduced in this case. collector and adapter (sold separately), most of dust can When the speed is too low, cutting will take longer, be collected.
- Page 8 Hitachi Power Tools are constantly being improved protection, carbon brush inspection and replacement and modified to incorporate the latest technological on this tool should ONLY be performed by a HITACHI advancements. AUTHORIZED SERVICE CENTER. Accordingly, some parts (i.e. code numbers and/or 5.
- Page 12 Hitachi Koki Co., Ltd. Code No. C99146311 N Printed in Japan...