Storing Components - Dell S4820T Installation Manual

CAUTION: Always disconnect the power cable before you service the power supply slots.
CAUTION: Use the power supply cord as the main disconnect device on the AC system. Ensure
that the socket-outlet is located/installed near the equipment and is easily accessible.

Storing Components

If you do not install your S4820T and components immediately, Dell Networking recommends properly
storing the system and all optional components until you are ready to install them.
WARNING: Electrostatic discharge (ESD) damage can occur when components are mishandled.
Always wear an ESD-preventive wrist or heel ground strap when handling the S4820T and its
accessories. After you remove the original packaging, place the S4820T and its components on
an antistatic surface.
Follow these storage guidelines:
• Storage temperature must remain constant ranging from -4° to 158°F (-20°C to 70°C).
• Store on a dry surface or floor, away from direct sunlight, heat, and air conditioning ducts.
• Store in a dust-free environment.
Site Preparations
15