IBM 7208 Model 345 Service Manual page 60

Table 7. Fault Symptom Codes (FSC) and Error Recovery Procedure (ERP) Numbers (continued)
FSC Description
The drive is not ready, but it is in process of becoming
C7
ready.
C8 A backup positioning command is required.
The specified command requires a tape and none is
C9
loaded.
CA The log threshold was met.
CB The log Parameter was changed.
The length of the parameter has caused an error in
CC
Command Descriptor Block (CDB).
CD An illegal Operation Code was used.
CE An incorrect field or reserved bits were set in the CDB.
CF This Logical Unit (LUN) is not supported.
An incorrect field exists in the Parameter List (Mode
D0
Data).
D1 An illegal bit is set in the identify message.
D2 Media removal is prevented.
The command issued has a mode mismatch
D3
(variable/fixed).
An illegal Transfer Length in was encountered in the
D4
CDB.
Could not change the MODE SELECT parameters since
D6 the tape was not at Logical Beginning Of Tape (LBOT)
(or Logical Beginning Of Partition (LBOP)).
The drive cannot read the media because it is in an
D7
incompatible format.
The commands overlapped and caused a bad
D8
Initiator-Target-Logical Unit (ITL) connection.
DA Illegal bits were set in an ID message.
The drive cannot write to tape because the cartridge is
DB
not AME format.
46
7208 Model 345 Service Guide
ERP Number Cause
3
2
7,3
3
3
D = 50%
2
S = 50%
D = 50%
2
S = 50%
D = 50%
2
S = 50%
D = 50%
2
S = 50%
D = 50%
2
S = 50%
D = 50%
2
S = 50%
D = 50%
2
S = 50%
D = 50%
2
S = 50%
D = 50%
2
S = 50%
D = 50%
2
S = 50%
D = 50%
14
S = 50%
D = 50%
2
S = 50%
D = 50%
2
S = 50%
14
I
I
I
I
I
I