Removing and Replacing the Cooling Fan
To remove the cooling fan:
1. Perform the cover removal procedure. Refer to "Removing and Replacing the
2. Disconnect the power supply connector (J2) ( 1 in Figure 14) between the
3. Remove the two screws, lockwashers, and nuts 2 that secure the cooling fan
4. Lift the cooling fan out of the 7208 Tape Drive.
To replace the cooling fan, reverse the removal procedure. Make sure that the
cooling fan is oriented so that air flows out from the rear of the 7208 Tape Drive.
Figure 14. Removing and Replacing the Cooling Fan
30
7208 Model 345 Service Guide
Cover" on page 26.
power supply and the cooling fan.
to the rear of the 7208 Tape Drive.