Set The Desired Room Temperature; Set The Heat Pump For Extra Hot Water - IVT Greenline HT Plus C Assembly, Commissioning And Maintenance Manual

Basic functions - Customer level 1

Set the desired room temperature

If you have a room sensor connected to the heat pump, use menu Room
temperature in the room from the Room temperature menu. From Extra
functions (Customer level 2) you can also set how much you want the sensor
to infl uence the heating system.
This is what to do:
1. Press the Heat button in the initial menu.
2. Turn the menu dial clockwise until you reach the menu Room temperature.
Room temperature
10° 20,0
Return Adjust
3. Press the Adjust button.
4. Turn the menu dial clockwise to increase the room temperature.
Turn the menu dial anti-clockwise to lower the room temperature.
5. Save the new value by pressing the Save button.

Set the heat pump for extra hot water

You can obtain extra hot water by temporarily increasing the temperature
of the water in the hot water cylinder. This may be appropriate when, for
example, a large number of people need to shower. On the control panel
and the menu Extra DHW you choose how long the function should run.
This is what to do:
1. Press the Heat button in the initial menu.
2. Turn the menu dial clockwise until you reach the menu Extra DHW.
Extra hotwater
1h 24h
Return Adjust
3. Press the Adjust button.
4. Turn the menu dial clockwise to choose the number of hours that the
electric cassette should be on (e.g. 24 hours).
Extra hotwater
1h 24h
Return Save
5. Save the value by pressing the Save button.
30°
48h
48h
The example describes how to set the
required room temperature with the
help of a connected room sensor. The
range is 10ºC to 30ºC.
When the set time has elapsed you
must repeat the setting to get extra
hot water again.
18
Note
Note