Inmarsat EXPLORER 700 Getting Started page 14

c. Monitor the signal strength on the status bar:
Use this information, and the signal strength reading on the terminal's display, to further adjust
the antenna position to obtain maximum signal strength. Remember not to touch the antenna.
Note If the signal strength is not sufficient, registration may not be possible and
terminal may not be able to establish a data connection.
d. When you have positioned the terminal to obtain the maximum signal strength, you are ready to
register with the network. Click on Register with Network now.
Tip You can also register with the network by pressing the OK button on the terminal's
keypad at any stage in the pointing process.
By default, BGAN LaunchPad opens a standard IP data connection after successful registration.
The status zone reads Standard Data Connection Open. Ready for Phone, Text and Data.
e. Use this information, and the signal strength reading on the terminal's display, to further adjust
the antenna position to obtain maximum signal strength. Remember not to touch the antenna.
Note If the signal strength is not sufficient, registration may not be possible and
terminal may not be able to establish a data connection.
f. When you have positioned the terminal to obtain the maximum signal strength, you are ready to
register with the network. Click on Register with Network now.
Tip You can also register with the network by pressing the OK button on the terminal's
keypad at any stage in the pointing process.
By default, BGAN LaunchPad opens a standard IP data connection after successful registration.
The status zone reads Standard Data Connection Open. Ready for Phone, Text and Data.
Tip You can make or receive phone calls, or send and receive a text message even if you do
not have an IP data connection.
Getting Started with the EXPLORER 700
the
the
Page 12