Inmarsat EXPLORER 700 Getting Started page 26

To enable and set up the Whitelist:
a. Select Terminal > WLAN Whitelist from the BGAN LaunchPad main menu. The Configure
WLAN Whitelist window displays, as shown below:
b. Select Enable to activate the Whitelist.
c. Type the MAC address of the computer that you want to add to the Whitelist into the boxes at
the foot of the screen, and click Add. This MAC address displays in the Allowed Devices list.
d. Repeat step c for all computers you want to add to the Whitelist. You can have a total of 10
computers on the Whitelist at any one time. Once 10 computers have been added, the Add
button greys out and you must delete a computer before you can add another computer to the
Whitelist.
e. Click OK to save the displayed information.
If the Whitelist is enabled, only those computers granted access can use the terminal's WLAN
interface. If you Disable the Whitelist, all computers in range can access the WLAN interface.
To delete one or more computers from the Whitelist, do the following:
a. Check the check box next to the computer(s) you want to delete from the Whitelist.
b. Click on Delete.
Tip The Bluetooth and WLAN interfaces may interfere with each other if they are both active.
For optimum performance, do not use Bluetooth and WLAN simultaneously, or use WLAN
mode 802.11a.
Getting Started with the EXPLORER 700 Page 24