Safety Devices; Commissioning And Operation; Description Of The Appliance - Kärcher K 3.160 Operating Instructions Manual

containing water or dirt.
Caution
 In case of extended downtimes, switch
the appliance off at the main switch / ap-
pliance switch or remove the mains
plug.
 Do not operate the appliance at temper-
atures below 0 °C.
 Observe a distance of at least 30 cm
when using the jet to clean painted sur-
faces to avoid damaging paintwork.
 Never leave the appliance unattended
when it is in operation.
 Make sure that the power cable or ex-
tension cables are not damaged by run-
ning over, pinching, dragging or similar.
Protect the power cable from heat, oil,
and sharp edges.
 All current-conducting parts in the work-
ing area must be protected against jet
water.
 The appliance may only be connected
to an electrical supply which has been
installed in accordance with IEC 60364.
 The appliance may only be connected
to alternating current. The voltage must
correspond with the type plate on the
appliance.
 The maximum tolerable mains imped-
ance at the electrical contact point (see
Technical Data) must not be exceeded.
 For safety reasons, we recommend that
you operate the appliance only via a
earth-leakage circuit breaker (max.
30 mA).
 Cleaning operations which produce oily
waste water, e.g. engine washes, un-
derbody washes, may only be carried
out using washing stations equipped
with an oil separator.
 This appliance was designed to be used
with detergents which are supplied or
recommended by the manufacturer.
The use of other detergents or chemi-
cals may compromise the safety of the
appliance.

Safety Devices

Caution
Safety devices protect the user and must
not be modified or bypassed.
Power switch
The appliance switch prevents unintention-
al operation of the appliance.
Lock trigger gun
This lock locks the lever of the trigger gun
and prevents the inadvertent start of the ap-
pliance.
Overflow valve with pressure switch
The overflow valve prevents the permissi-
ble working pressure from being exceeded.
If the lever on the trigger gun is released the
pressure switch turns off the pump, the
high-pressure jet is stopped. If the lever is
pulled the pump is turned on again.
Commissioning and
operation

Description of the Appliance

When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
Illustrations on Page 2
1 Coupling element for water connection
2 Connection for water supply with filter
3 High pressure connection
4 Appliance switch "0/OFF"/ „I/ON"
5 Detergent Tank
6 Suction hose for detergent
7 Transport handle
8 Storage for accessories
9 Mains cable with mains plug
10 Trigger gun
11 Lock trigger gun
12 High pressure hose
13 Key to detach the high-pressure hose
from the trigger gun
5
English