Using Your Kambrook Multi Oven; Temp. (Orange) Light; Preheating; Setting The Mechanical Timer - Kambrook KOT500 Owner's Manual

Using your Kambrook
Multi Oven
Before first use remove any promotional
labels.
Place the Multi Oven on a level, flat
surface.
Plug the appliance into a 230/240-volt
power outlet.Turn the power on.
IMPORTANT:The oven will not heat
until ALL of the following are activated:
• The 'Element Control Switch' is in
position I or II.
• Timer is activated
• Temperature is selected
The element switch
The element switch is able to select 'top
and bottom' element on or 'top only'
element on.The bottom element is unable
to be selected by itself.

Setting the mechanical timer

I = 'Top element only' for grilling.
'Top & bottom elements'
together for roasting,
II =
toasting, baking.
Note: For even cooking (top and bottom) only one
element at the top will illuminate, as well as the
bottom element.
For setting cooking times less than 30
minutes - turn the timer dial past the 45
minute mark, then turn back to the
desired time. ie/ for 10 minutes of
cooking, turn the dial to 45 minutes then
immediately turn back to 10 minutes.
Power (red) light
This light will turn 'on' when the Element
Control Switch in position I or II.

Temp. (orange) light

The light will illuminate as the oven is
heating and will turn off when the oven
has reached the selected temperature
ie/ preheated. It will cycle on and off
throughout the cooking process.

Preheating

For best results allow the Multi Oven to
pre-heat before using the oven. Select the
desired temperature. Set the timer dial to
90 minutes, heat until the Temp. light
switches off.
Using the Element Protection Tray
The element protection tray (the flat
silver look tray) is designed to protect the
element from falling food.When cooking
in a baking tray or any oven proof
container, remove the element protection
tray to achieve correct cooking
temperature. However when not using
any cooking tray/container ie/ toasting
cheese sandwiches on the wire rack,
ensure the element protection tray is in
place.
Roasting, Baking, and Reheating
Position the wire rack to the required
shelf height.
Select the required temperature on the
'Temperature Control Dial'.
Select 'top and bottom' elements on the
Element Control Switch.
Preheat the oven.
Place the food inside the oven and select
the desired time.
The Multi Oven will switch off when the
timer switches off.
5