SENAO SN-358 SKYPE Instruction Manual page 16

4. Answering Calls
Press to answer a call.
To hang up, press
4. Paging the target handset from the base unit
1. N N
Once only press
To stop paging, press
2. To accept a page, press any key except
handset is docked.
3. To end the intercom, press
NOTE: Once paging from the base unit, a confirmed melody will sounds if the
base unit receives the response from the handset. If the melody does not sound, it
means that:
(1) The handset is off.
(2) The handset is out of communication range.
5. Intercom during a call
While you are using the base unit to make or answer an incoming call, there are 2
methods to page the handset and still keep your current telephone call.
1. If you want to talk to any handset, simply press the
put the current telephone line on hold, play the hold music to the line, and the
base unit will begin paging all handsets. Any handset can answer the page.
2. If you would like to talk to a specific handset, follow these steps:
HOLD
( N N is the handset ID of target handset)
This operation will send the current telephone call on hold music, and the base
unit will page a specific handset ID N N . Only the handset with the unique ID
number N N will be paged.
3. During handset and base unit conversation, either the base unit or the handset
can resume conversation with the call on hold by pressing
or on the handset.
6. Transfer a phone
While you are using the base unit to make or answer an incoming call, there are two
methods to transfer the call over to other handsets.
again.
paging ( N N is the ID of target handset)
key, it Means paging all handsets.
again.
key or place the handset back onto the Charger.
N N paging
or remove from the charger if
15
key only. It will
on the base unit,