Module Information; Module Information Webpage Fields; Configuration Examples; Factory Default Settings - Weidmuller WI-MOD-E-G User Manual

Wireless ethernet modem & device server
Table of Contents

Advertisement

Weidmuller Wireless Ethernet Modem & Device Server WI-MOD-E-G/A User Manual

3.24 - Module Information

Module Information Webpage Fields

This configuration page is primarily for information purposes. With the exception of the password, the information entered
here is displayed on the home configuration webpage of the WI-MOD-E.
Username
Configuration of Username. This is the username used to access the configuration on
the WI-MOD-E. Take care to remember this username if you change it as it will be
needed to access the WI-MOD-E in future.
Password
Configuration of Password. This is the password used to access the configuration on
the WI-MOD-E. Take care to remember this password if you change it as it will be
needed to access the module in future.
Device Name
A text field if you wish to label the particular WI-MOD-E. This is also the DNS name
(hostname) of the device if you are using DNS.
Owner
A text field for owner name.
Contact
A text field for owner phone number, email address etc.
Description
A text field used for a description of the purpose of the unit.
Location
A text field used to describe the location of the WI-MOD-E.

3.25 - Configuration Examples

Factory Default Settings

Access configuration webpage on the WI-MOD-E. Refer section 3.2 - "Configuring the Unit for the first time"
Click on "System Tools" Menu Item
Click on Factory Default Configuration Reset, and wait for unit to reset. While the module executes the reset
sequence the OK LED will flash. The OK LED will turn green when the reset sequence is complete.

Extending a wired network

Access Point Configuration

Connect straight through Ethernet cable between PC and WI-MOD-E.
Ensure configuration PC and WI-MOD-E are setup to communicate on the same network
Set dipswitch to SETUP mode.
Power up unit, and wait for the OK LED to cease flashing.
Adjust PC network settings
Set Configuration PC network card with network setting of IP address 192.168.0.1, Netmask 255.255.255.0
Rev. 2.16 
Figure 64 - Example Config 1
www.weidmuller.com  
 
71 

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wi-mod-e-a

Table of Contents