Jperf Application - Weidmuller WI-MOD-E-G User Manual

Weidmuller Wireless Ethernet Modem & Device Server WI-MOD-E-G/A User Manual

JPerf Application

Jperf is a graphical interface that runs over the top of Iperf. It will display a graph result from the Iperf test.
To run Jperf open a CMD prompt and change to the "jperf-2.0.2: directory and run the "Jperf" application as shown in
Figure 4. The CMD screen will disappear and the Jperf Screen will appear as seen in Figure 5.
When Jperf screen appears select Client Mode, enter in IP address of the Server PC; leave Port as default and press Run
Iperf button. The test will run again and the Bandwidth (Throughput) display will show results of the test.
Note: Jperf runs using Java technology and depending on PC setup further installation of Java software
may be required.
Rev. 2.16
Figure 4
Figure 5
www.weidmuller.com 106