Table of Contents
Advertisement
3. Names of each part
●
Part names
Projector
Vent
Lens
Lens cover
Lamp cover
(Lamp unit is inside.)
Control buttons
Ports
(See below.)
RGB port
Restart switch
CONTROL port
Kensington lock slot
NOTE (*) About Restart switch: This Projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar and before
turning on again, make the projector cool down at least 10 minutes without
operating. Only push the Restart switch in these exceptional instances.
PJ-LC9(C12H)
Front-Right side
Bottom side
Rear-Left side
RGB
CONTROL
S-VIDEO
K
Ports
3
Focus ring
Remote sensor
Speaker
Elevator button
Elevator foot
Filter cover
(Air filter and intake vent
are inside.)
Power switch
AC inlet
Elevator button
Elevator foot
Vent
S-VIDEO port
VIDEO port
VIDEO
AUDIO
AUDIO port
Advertisement
Table of Contents
