Table of Contents
Advertisement
7
Tools Needed:
Let wrench rotate clockwise for the right side, counter clockwise for the left side until desired tension is achieved as shown in
FIG. 7.3. Re-engage the pawl (1r) by pushing on it with a finger, ensuring it seats properly in between the teeth of the gear (1t),
Ratchet Wrench
as shown in FIG. 7.2, and then, gently release the wrench (B4 and B5) clockwise for the right side, counter clockwise for the left
side, until pawl is engaged in the gear. Carefully remove the wrench from gear. In case of TorqueMaster® with two springs,
75mm (3")
repeat for opposite side, until desired tension is achieved.
Extension
After and only after spring adjustment and door balance checked, the installation of an external electrical operator is possible.
To dismantle the installed garage door system, remove the garage door system in the reverse order in which it was installed in the installation section of
this manual. Check local codes for proper discardment.
To open the door, rotate either the inside or outside handle 45 degrees until the handle locks into place and the door lock unlatches. Use the furnished
handles to open and close the door manually.
On closing the door, ensure the door latches securely when completely closed by rotating the handle back to the original position.
The door does not automatically lock when closed manually. To lock and unlock the door, use the provided key or the locking pin.
FROM THE OUTSIDE:
Use the provided key.
To unlock: Turn the key counterclockwise 360°.
To lock: Turn the key clockwise 360°.
FROM THE INSIDE:
Actuate the locking pin on the lock.
To unlock: Push the locking pin down.
To lock: Push the locking pin up.
NOTE: If using the door with an automatic garage door opener, the door lock must be removed or made in operative, in unlock position.
Spring Adjustment (If Required) - Continued
(See Diagram 7 on page 6 of Drawings of Installation, Use and Maintenance manual)
External Electrical Operator Installation (If Required)
(see : Manual of Installation supplied with the operator)
DISMANTLE AND DISCARDMENT
OPENING AND CLOSING
LOCKING AND UNLOCKING
8
Advertisement
Table of Contents
