Front Wheel Bearings With Oil-Filled Hubs; Air Conditioning System - GMC C series 2002 Owner's Manual

6. Install a new gasket whenever you take out the
cylinder. Use only one gasket and spread a light film
of clean oil on it before installation.
7. Put in the new cylinder. Turn it clockwise until it just
starts to contact the gasket.
8. Tighten the cylinder another half turn (180 degrees).
-
Don't over tighten.
9. Retighten the cylinder clamp.

Front Wheel Bearings with Oil-Filled Hubs

-
If your vehicle has oil filled
hubs, occasionally check to
see if they have enough oil.
You can tell by looking into
the sight glass to see if there
is oil there.
If there isn't, clean the rubber fill plug in the center of
the glass, and then remove it. Be careful not to allow
any dirt or water to get into the oil. Add enough of the
recommended oil to bring it up to the level mark that
you'll see on the glass.
Refer to your Maintenance Schedule for the proper
oil to use.
When you fill the hub, check the glass again after
driving a short distance. It takes a while for the oil to
flow through the system, and you may find that you
have to add a little more to fill it to the proper level. Be
sure not to overfill the hub.

Air Conditioning System

Every now and then, have your dealership check your
air conditioning system to be sure it has not lost any
cooling ability. If you think the system is not working
properly, have your GM Truck dealer check it out as
soon as possible.
The air conditioning won't work when the temperature
outside is below 40 _ F (4 _ C).
6-47