Scott 2014 BIKE Owner's Manual page 5

BRAKES
Brake adjustment general
Your SCOTT bike is fitted with a reliable and well-functioning braking system, provided
the brakes are correctly adjusted. Check by measuring the distance between the brake
shoes and the rim: it should be 1.5 to 2 mm.
Cable connection and adjustment of the (Dual Pivot) brake
1. Put the quick lever on the closed position.
2. Adjust the brake shoe clearance (as shown in the illustration) and secure the cable
with the pinch bolt nut.
Cable bolt tightening torque 6-8 Nm
centering adjustment bolt Zentrierschraube
open
offen
3mm allen key 3mm-Inbusschlüssel
geschlossen closed
A B
+ = 3 - 4 mm
quick release lever Schnellspannhebel
1
2
2
1
2
Change of brake pads
1. Loosen up the security screw with a 2 mm allen key.
2. Push the used brake pad out of the aluminium brake shoe.
3. Push the new brake pad into the brake shoe, and beware of the arrow which
shows the mounting direction.
4. Tighten up the security screw to approximately 1.5 Nm.
8
BIKE OWNER'S MANUAL
Replacement of the cartridge shoe Austauschen der Bremsschuheinheit
Die Schraube lösen.
Loosen the screw
2mm Inbusschlüssel
2mm allen key
screw Schraube
remove the shoe by sliding it along the groove of the shoe holder Schieben Sie den Bremsschuh zum Abnehmen aus der Bremsschuhhalternut.
Bremsschuh
shoe
There are two different types of shoe and shoe holder to be used in the left and Auf der rechten und linken Seite werden verschiedene Bremsschuhe und
right positions respectively. Slide the new shoes into the grooves on the shoe Bremsschuhhalter verwendet. Schieben Sie den neuen Bremsschuh in die
holders while taking note of the correct directions and screw hole positions.
Bremsschuhhalternut und achten Sie darauf, daß die Einschubrichtung und die
Schraubenlöcher richtig übereinstimmen.
for the left für linke Seite for the right für rechte Seite
gleich für vorne und hinten
same at front and rear gleich für vorne und hinten same at front and rear
vorne
vorne
front front
Bremsschuh Bremsschuh
brake shoe brake shoe
brake shoe holder Bremsschuhhalter brake shoe holder Bremsschuhhalter
shoe insertion Bremsschuh-
direction
einschub-
Schraube
screw Schraube
screw
richtung
tighten the set screw Die Schraube wieder festziehen.
tightening torque: 1-1,5 Nm (9-13 in. lbs.) Anzugsdrehmoment: 1 - 1,5 Nm
Centring the brake shoes
Make a minor adjustment by using the centring adjustment screw.
Readjustment of the brake shoe clearance
Turn the cable-adjustment bolt to readjust the brake shoe clearance.
centering adjustment bolt
9
scott-sports.com