Table of Contents
Advertisement
6.0 Operation
6.0 Operation
IMPORTANT: DO NOT ATTEMPT TO OPERATE THE CUTTER UNTIL
YOU HAVE THOROUGHLY READ AND UNDERSTAND ALL OF THE FOLLOWING
INSTRUCTIONS. CALL YOUR AUTHORIZED CHALLENGE DEALER IF YOU STILL HAVE ANY
QUESTIONS.
6.1 Power – Main Switch
Power is enabled when the main power switch is turned to the "ON" position (Figure 6). The display
and line light are turned on at this time.
Figure 6 –Power On-Off Switch and Circuit Breaker
If the knife is not at the "up" postion when the main power switch is turned
on, the knife will automatically move to the "up" position.
NOTE: The main power switch is also a circuit breaker and will automatically switch off in the event
of too much current running through the switch, such as from an electrical short. To reset the circuit
breaker, simply push the switch to the "on" position.
6.2 Backgauge Control
The backgauge is used to position paper to the desired location when cutting. The backgauge is
operated by the hand crank at the front of the machine. The backgauge position is shown by a
lighted LED display. When the machine is first powered up, the display shows four lines as follows,
indicating the display needs to be reset.
Figure 7 – Display at power up
11
Advertisement
Table of Contents
