Cord Instructions; Beverage Cooler Installation - Vinotemp VT-BLKBEV Owner's Manual

For your protection, this unit should be properly
grounded. Unit is equipped with a 3-conductor
cord set that has a molded 3-prong grounding-
type plug, and should be used in combination
with a properly connected grounding-type outlet
shown in figure A.
It is not recommended to use this beverage
cooler with an extension cord or power board. Please ensure that the appliance is
plugged directly into the electrical outlet.
• Remove the exterior and interior packaging before use.
• Check to be sure you have all cooler parts and 1 owner's manual.
• Place your beverage cooler on a flat, dry surface that is strong enough to
support the unit when fully loaded.
• This unit is designed for freestanding installation only.
• Do not place heavy objects on top of the unit.
• Unit is not designed for installation in a garage, basement, or any other location
where a controlled ambient environment between 60° and 90°F cannot be
maintained.
• Do not place the unit in direct sunlight or near sources of heat. Extreme hot and
cold ambient temperatures may cause the unit not to perform properly or
increase electrical consumption.
• Do not place the unit next to a major appliance that emits large amounts of heat,
such as a dishwasher, microwave, oven, etc.
• Do not plug unit into the same outlet as a refrigerator or microwave.
• Before connecting the appliance to the power source, let it stand upright for
approximately 24 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth before first use.
• The unit is designed for freestanding installation only. It is not designed to be
installed under a counter, inside a cabinet, or in any location that does not allow
the proper clearances on all sides, as stated above.
• IMPORTANT: To function correctly, beverage cooler needs a minimum of 10-12
inches clearance on each side and 6 inches clearance at the back.
6

CORD INSTRUCTIONS

BEVERAGE COOLER INSTALLATION

W W W . V I N O T E M P . C O M
as