M
aintenance and care
machine care (check regularly)
Cleaning suction gate
the suction gate automatically diverts air
when the portable deep cleaner is detached.
this should be checked and cleaned
regularly for any dirt and debris.
1. step on the pedal and remove
the portable spot cleaner. Remove
dirty tank.
2. Remove two screws and pull off
suction gate door.
3. Wipe suction gate clean and rinse
suction gate door.
4. Replace suction gate door and
two screws.
Cleaning spray tips
1. step on the pedal and remove the
portable spot cleaner. to remove each
spray tip, push tab in and pull it out.
2. clean by rinsing under hot water.
3. Replace by snapping back in.
w w w . b i s s e l l . c o m
WARNING:
to reduce the risk of fire,
electric shock, or injury, turn
power off and disconnect
plug from electrical outlet
before performing maintenance
or troubleshooting.
2.
Suction
Gate
Spray
Tips
1.
8 0 0 . 2 3 7 . 7 6 9 1
13
Need help?
Do you have a question about the LIFT-OFF Deep Cleaner and is the answer not in the manual?
Questions and answers
will not **** up water properly
The Bissell LIFT-OFF Deep Cleaner may not be picking up water properly for the following reasons:
1. Tank not seated properly: Ensure both tanks are picked up and reseated so they fit snugly on the unit.
2. Nozzle not assembled correctly: Verify the nozzle cover's "lip" is securely hooked into the groove at the top of the nozzle.
3. Portable spot cleaner not attached completely: Check that the portable spot cleaner is firmly attached by pushing it down completely.
4. Dirty tank is full: Empty the dirty tank if it has reached the maximum fill line.
5. Formula and water tank is empty: Check the fluid levels in the formula and water tank and refill if necessary.
6. Suction gate is open: Ensure the suction gate is closed by following the instructions in the manual.
If none of these steps resolve the issue, contact BISSELL Consumer Care for further assistance.
This answer is automatically generated