Bissell LIFT-OFF Deep Cleaner User Manual page 12

Lift-off deep cleaner 24a4, 30k7, 66e1, 80x9 series

Hide thumbs

Table Of Contents

Table of Contents

perations

Portable spot cleaning mode continued

Cleaning with Deep Reach™ Tool

1. set tool on soiled surfaces and press the

trigger to spray solution onto the soiled

area to be cleaned.

2. slowly move the tool back and forth

over the soiled surface, keeping the tool

in contact with the carpet.

Release trigger and move tool slowly

over the soiled area to suction up

water and dirt.

4. continue to clean the area, working

in small sections, until no more dirt

can be removed.

Empty dirty tank

follow the instructions under empty dirty

tank section on page 9 of the upright

cleaning mode section.

Replacing portable machine on base

1. align the product with the cord side on

the left and hose side on the right.

2. Push down the portable spot cleaner

until both sides click securely into place.

test the fit by pulling up on the carry

handle to make sure it is secure.

Cleaning portable machine

1. Remove and rinse the tools in clean,

running water. dry and replace in the

tool storage provided.

2. it is recommended that you suction clean

water from a bowl to rinse out the hose.

then lift end of hose and stretch out to

ensure all water is cleared from hose.

3. coil flex hose around the hose wrap

and secure with latch.

4. check suction gate and if it appears

dirty, follow steps 1-4 under cleaning

suction gate on page 13.

CORD

SIDE

HOSE

SIDE

Table of Contents

Show Quick Links

Hide quick links:

Table of Contents

Need help?

Do you have a question about the LIFT-OFF Deep Cleaner and is the answer not in the manual?

Questions and answers

Sharron Joan Miners

January 20, 2025

will not **** up water properly

1 comments:

Mr. Anderson

February 4, 2025

The Bissell LIFT-OFF Deep Cleaner may not be picking up water properly for the following reasons:

1. Tank not seated properly: Ensure both tanks are picked up and reseated so they fit snugly on the unit.
2. Nozzle not assembled correctly: Verify the nozzle cover's "lip" is securely hooked into the groove at the top of the nozzle.
3. Portable spot cleaner not attached completely: Check that the portable spot cleaner is firmly attached by pushing it down completely.
4. Dirty tank is full: Empty the dirty tank if it has reached the maximum fill line.
5. Formula and water tank is empty: Check the fluid levels in the formula and water tank and refill if necessary.
6. Suction gate is open: Ensure the suction gate is closed by following the instructions in the manual.

If none of these steps resolve the issue, contact BISSELL Consumer Care for further assistance.