Install The Hood - Broan 15000 SERIES Instructions Manual

INSTALL THE H OOD
1. Mark and cut-out cabinet bottom.
Prepare the cabinet bottom as shown above. Be sure to lo-
cate the cut-out and four holes from the front of the cabinet
to assure a flush mount.
2. Attach damper/duct connector.
Use two (2) screws (provided) to attach connector to housing.
Damper flap should open in direction indicated by arrow.
3. Remove electrical knockout.
Choose either the top or side of housing for electrical cable
entrance. Remove the appropriate knockout.
4. Set housing into opening.
Carefully lower housing into cabinet opening with slide control
to the front.
5. Remove access cover.
6. Open filter panel.
Pull drawer slides out. Rotate panel clips and swing panel
open.